I wanted to do this solo as a test of my novice rope skills. The trail started by descending into Cougar Canyon. Once you get into Cougar Canyon, a faint use trail comes and goes, but it is generally easy to follow even if you lose the use trail. I crossed water in the canyon several times before reaching the point to leave the canyon and head toward the granite pinnacles guarding Square Top. I skirted the flank of a prominent pinnacle, then followed the remnants of an old road before dropping down into the south fork of Sheep Canyon. As I started up the south slope of Square Top, I had problems with my make-shift rope bag. I packed the rope, rock shoes, gloves, webbing, autoblock, and carabiners in a bag meant for snowshoes. It weighed 12 pounds and had a strap that I carried over my shoulder. The extra weight slowed me down, and any scrambling caused the bag to slide around and create imbalances. Square Top was steep class 2 and it was tiring to carry all that gear up to the summit area.
Square Top
Looking down near the top of the south slope
Once I got to the top, I unpacked the rope and gear, then walked around the summit block to figure out the best direction to make my attempt. The west side looked like the easiest (as other reports had mentioned) so I started hunting for an anchor on the other side. I wrapped 1" nylon webbing under a boulder and evened it out in a basket hitch. Next, I attached the rope to the anchor with a double figure 8 and two opposite facing carabiners. The next step was to throw the rope over the summit block. This turned out to be my biggest problem. My first throw went over the wrong edge and I couldn't position it correctly. My next nine plus throws, I lost count, were whipped off the north side by a strong and steady 25mph wind. The wind gusted up to 40mph and it created havoc with my throws. I tried to compensate by throwing the rope south without luck. I thought seriously about giving up on the rope, but I didn't want to try an unprotected ascent with the wind howling so hard. Finally, I tied a knot to the loose end and attached three carabiners. I eventually got the rope over. The last thing to do was get my harness on and set up the two prusik knots I used to ascend. The beginning of the block is vertical with no real holds. I used the lower prusik as a foothold, and the upper as protection, alternating the load between the two to move the other one up. It was kind of an awkward ascent, but it worked and my anchor felt strong. After I got past the vertical section, I left the lower prusik behind. The rock after that was more of a class 3 friction climb and I just used the upper prusik as protection. Just over half way, a gust of wind tore my hat off and it tumbled over the side. I was too stoked to worry about it and reached the top shortly after. In all, I spent about an hour and a half on the summit.
Final resting place of my hat
Collins Valley and assorted benchmarks
Collins benchmark, a tough SDC peak for a future hike
Random pinnacles in the area
Back on the ground, I hunted down my hat and checked out the register. The register was in a pair of yellow cans, a variation on the normal red. There were two small registers inside, the oldest one going back to 1991. Heading down Square Top, I had the same imbalance issues with my rope bag. Maybe I'll try bringing a large pack that I can stuff all the gear into next time. Getting the class 5 block and handling every aspect of the rope system was a first for me. It was a great starter peak for rope practice. If you are interested, I have a few 360 photospheres on my blog.
